Skip to content

Volume Discounts Apply At Checkout

ATLANTIS - Egg Shape Pot Evergreen Trees Direct

About Your New ATLANTIS - Egg Shape Pot

The Atlantis Egg Shape Pot is a hand-made glazed vessel with the rounded, tapered profile of an egg. It belongs to the Atlantis range, made new but finished to look as though it has been salvaged from the sea. The crusty glaze runs from whitish through toasted shades, occasionally with hints of turquoise.

It is frost resistant and holds up outdoors through Australian winters. The glaze may shed a little when the film wrap first comes off, which settles quickly. Because each pot is hand-made, dimensions are approximate and no two finishes are identical. The fired body also suits use as a flowing water feature.

Use it at an entrance, in a courtyard, on a terrace or beside a pool, where the coastal glaze reads well against stone and timber. The egg shape suits a clipped ball of buxus, a small olive, or a loose planting of succulents. It works singly or as a matched pair.

Frequently Asked Questions

About Atlantis Egg Shape Pot

What is the Atlantis Egg Shape Pot made from?

It is a hand-made glazed pot, finished with a crusty glaze that ranges from whitish through toasted shades, sometimes with hints of turquoise. The surface is made new but deliberately finished to look weathered, as though it has spent time in the sea. Because the glaze is applied by hand, no two pots come out quite the same.

What sizes does the Atlantis egg pot come in?

Three sizes are made: D54 x H43cm, D47 x H37cm and D37 x H30cm. Dimensions are approximate because the pots are hand-made and sizes vary a little from piece to piece. If you are fitting a pot into a tight alcove or a set space, allow a few centimetres either way.

Is the Atlantis pot frost resistant?

Yes. The Atlantis pots, urns and jars are frost resistant, so they can stay outside through winter in most Australian conditions. As with any planter, keep the drainage clear so water does not sit in the base and freeze. Raising the pot slightly on feet helps water move away after heavy rain.

Can it be used as a water feature?

Yes. The Atlantis range is well suited to flowing water features, and the glaze reads particularly well when wet. As with any pot used to hold water, the inside should be properly sealed before it is filled. A little glaze may shed when the film wrap first comes off, which settles quickly.

Does the finish vary between pots?

It does. Every pot is hand-made and hand-glazed, so the crusty surface shifts between whitish and toasted tones, with the odd hint of turquoise. Finishes may vary from the pot shown in the photograph. If you are ordering several for a matched grouping, expect a family resemblance rather than an exact match.

What size plant suits this pot?

The largest at D54 x H43cm takes a clipped buxus or ficus ball, a small olive or a compact citrus. The D47 x H37cm size suits a mid sized topiary or a mass of succulents. The smallest at D37 x H30cm is better with herbs, sedums or a single sculptural agave.

How do I clean and care for it?

Wash it with mild soapy water and a soft bristle brush or a rag, then rinse. Avoid harsh chemicals and abrasives, which will dull the glaze. Mineral marks from potting mix can be wiped back as they appear. Empty the pot before a hard freeze if it is holding water.

Evergreen Trees Direct Has Been Featured In:

Load video:

Uses in my Garden

  • Plant in Pots (or) Suitable for Pots

ATLANTIS - Egg Shape Pot works in an:

  • Mediterranean Style Garden – timeless courtyard look with stone, pots, and bold greenery.
  • Coastal Garden – relaxed, seaside feel with hardy, textural plants.
  • Modern Garden – sleek, minimal, and design-led planting.
  • Formal Garden – structured, symmetrical design with clipped shapes.

youtube Load video:

Planting Information

youtube Load video:
Evergreen Trees Direct
Evergreen Trees Direct
Evergreen Trees Direct

Elevate Your Garden

Follow Us On Instagram

@evergreentreedirect
Evergreen Trees Direct
Evergreen Trees Direct